acer predator 300 PH315-51 Wifi and power management issues

[stackoverflow]

Hello,

First of all thanks to the forum and the contributors for a great work being done.

I have acer predator 300 PH315-651

Core i5 8300H coffee lake, 16 GB ram

Intel AC 9560 wireless and Realtek audio

Using Catalina image I am able to boot into Catalina but facing the following issues

1. the wifi does not work, I tried kext itlwm.kext and the related bluetooth kext, it worked once but does not work again on reboot. I have copied the kext on clover/kext/other folder both on the USB drive and the hard drive. May be I am not sure how to configure and use clover as clover configurator does not show any drivers

2.   The power management does not work, the battery % is not shown - it shows 0%

3. Is there a way to Put the laptop in sleep mode?

Thanks 

 

[MaLd0n]

Post one Full Dump
https://www.olarila.com/topic/10301-olarila-runme-dumper/
https://olarila.com/files/Utils/RunMe.app.zip

[stackoverflow]

Hello,

Thanks for the message. Please find a link to the Send me file.

https://drive.google.com/file/d/1cVxTE4JMeu0jUhmFO8Sbf7StUQgh9Cv2/view?usp=sharing

Few queries

1. I copied some kext to the USB EFI - kext\others folderwith which I can see the laptop battery %

2. However the WIFI does not work - even if I copied the lwitm.kext on the USB drive

3. I would like to know how to boot from the SATA driver I have as that still does not seem to work and I need to boot via USB only

Thanks.

[MaLd0n]

first u need update things, config very old

https://www.olarila.com/topic/10934-guide-new-clover-bootloader-integration-quirks-configuration/

[stackoverflow]

Hello,

Yesterday I tried to update the clover from 5122 to 5125 on the hard disk and also copied the corresponding config.plist.

With this I get the clover boot menu but the boot hangs.

I copied the same .plist on the USB drive - from which when I boot I still get the same issue of wifi not being identified.

Today I again try to upgrade clover but the installation fails(screenshot attached)

So I am still booting from USB but the wifi still does not work

 

clover_failure.zip

Edited October 29, 2020 by stackoverflow

[MaLd0n]

just need replace files

Archive.zip

[stackoverflow]

Hello,

Thanks for your message. 

I replaced the files posted earlier but was not able to boot from HDD.

I also updated clover to 5126 but it was still not booting from HDD.

So I finally copied the EFI folder from the PEN drive to the HDD EFI and now it is able to boot from HDD.

However it shows clover 5122.

I also followed the guide at https://www.olarila.com/topic/5794-hackintosh-guide-install-macos-with-vanilla-olarila-image-step-by-step-install-and-post-install-windows-linux-or-mac/ but was not able to boot from HDD.

Kindly let me know how to fix this. It seems that intel gfx intel 630 being used is not accelerated.

Also I would like to know how to configure the fans and other configurations

pl find the latest run me ---

https://drive.google.com/file/d/1uLVk0piL4BtTRV9uBwFFRFlPbeLHGVW5/view?usp=sharing

Thanks.

 

[MaLd0n]

need check a good config for quirks