LOW single core freq on 12.5 Monterey

[Adam Peter]

I'm running 12.5 on Asus x99 with E5 2696 v3 Xeon.
The bios is unlocked for max turbo ( for xeon) and also MSR 0xe2 unlock.
Lately the single core wont go higher than 2.8 when it should be 3.8 Ghz.
The all core turbo is even better than it was , the problem is with the single core pref.
I will upload the EFI maybe someone can spot, anything wrong.
Thanks

EFI.zip

[MaLd0n]

first disable all kernel patches and test

[Adam Peter]

I disabled all of them still the same , the guys from tony said it s a problem that I use DSDT and not SSDT.

I have no clue.

Thanks for the reply Maldon!!!!

 config.plist.zip

[MaLd0n]

3 hours ago, Adam Peter said:

I disabled all of them still the same , the guys from tony said it s a problem that I use DSDT and not SSDT.

SSDT's just inject into dsdt. this guy don't have idea about nothing.

If u use DSDT from ur mobo need work much better instead SSDTs.

https://www.transfernow.net/dl/20220807QZzVZVCu

 

[Adam Peter]

Thanks for the reply Maldon , I can't boot off the EFI u sent me even after cleared NVRAM.

I forgot to tell you if I deselect all kernel patches the cpu gets very hot 65-70 degrees on idle (with patches 42)

There are no new xcpm patches Nmano closed the thread " The contents of these post are outdated, all the XCPM patches for X99 and similar chipsets can be enabled within Kernel → Quirks section" 

If I enable AppleCpuPmCfgLock, AppleXcpmExtraMsrs, AppleXcpmForceBoost same result high CPU Temps if disable same.

Bios is set to C1 C3 enabled and C6 non retention state.

Thanks again 

[MaLd0n]

try start with olarila efi folder for ur processor