Greetings to all and my special thanks to MaLd0n for his great work and contributions to this comunity.
After invest a lot of hours reading here and there and following mostly the steps described in Vanilla install guide, finally I have managed to run successfully hackintosh in my desktop.
Well, there are still some unsolved problems that I would like to fix:
I have tried several combinations to create my own USB ports table by following the guide included in Hackintool's help, but as result, the 2 USB3.1(Gen1) from the case only recognize USB2.0 devices and card reader slots are not powered when inserted any card. If I use USBInjectAll.kext + XHCI-unsupported.kext + latest Mojave 10.14.4 USB kext patches in Clover config, all ports works with no issues.
Same for Intel HD 630 connectors mapping. My MOBO has only DVI and HDMI outputs and the default configuration in Hackintool for platform ID 0x59120000 shows 3 DP active ports instead. I would appreciate if any can help me with the correct connector index and their corresponding Bus ID/Type for ASUS Z270H. Currently I'm using agdpmod=vit9696 and -disablegfxfirmware boot flags plus DP -> HDMI framebuffer patch under Devices/Properties in Clover, but even if it runs with full hardware accelaration, I think this is not the best solution.
Black screen after power up from sleep, maybe in relation with described in the previous point. I have to press and hold case power button to force shutdown.
I have attached my send_me.zip for you to check. Many thanks.
Send me Davids-iMac.zip
