ktrofimov

Tried iatkos ML2 10.8.2 today. Problem still I can't boot both installation and installed system without -x flag (safe mode). But using this package I was finally able to finish installation. With kext helper I did install exotic qe ci patch for my hd4890 video. After reboot (with -x flag again) system info shows video card and display correctly. Where to look to get rid of safe boot mode??? DSDT? smbios? Too bad, morherboard BIOS is quite simple I even did not found HPET settings, while Inte's report says it should be there, in chipset settings... Looked everywhere - nothing about HPET

Didn't help Still [iOBluetoothHCIController][start] -- completed or gray screen right after this phrase and rainbow cursor... Using 10.8.5 USB I was able to start installation at least. But it was always unsuccessful - in couple of minutes before end I'v got KP and immediate reboot (I could not even catch the reason of KP) Using this 10.8.4 USB installation do not start at all... If I understood correctly I can use only 10.8 ML series and up because of Ivy Bridge CPU...

Same effect - gray screen with Apple logo and rainbow waiting cursor

No success I could not even get to the installation: Kernel Panic on AppleCPUPowerManagement - replaced by NullCPUPowerManagement hung on AppleSMC - replaced by FakeSMC Everything else (including -x -f options) failed same as before - in gray screen with Apple logo and rainbow waiting cursor Deleted ATI* NVDA* and AppleIntelHD* kexts from USB flash - gives no difference Last string I saw is again [iOBluetoothHCIController][start] -- completed

Ok. Will try it

boot options are -v -f Last string is [iOBluetoothHCIController][start] -- completed After this message screen goes to gray with apple logo and rainbow waiting cursor - look at "> Thanks!

Thanks. Yes, I understood you. Trying your USB image I'm stock with the same problem - I still can boot in safe mode only.... Deleting video kexts, clearing cache, booting without GraphicsInjector does not help System boots with -x flag only... Using different videocard (GF8400GS) I can now boot with high resolution graphics, but again - in safe mode only... What information could I post to dig this problem? Thank you again!

Hello! Can somebody guide me... I am trying to install ML 10.8.2 usuing the latest myHack 3.2B8 USB. Hardware: MB: Intel DH61HO CPU: i5-3570s Ivy Bridge Video: Saphire HD 4890 Up until now I can install and run ML only in safe mode -x All other options gives different results but most of the time system simply hangs during boot Log shows nothing special and last lines are: DSMOS has arrived [iOBluetoothHCIController][start] -- completed And then - nothing... In safe mode I can boot ML, but most things, of coarse, are not working Appreciate any help!