Moah
-
Posts
5 -
Joined
-
Last visited
Everything posted by Moah
-
Sorry I'm a beginner in hackintosh In the config.plist I assumed this was the video patch so I replaced the "enable" with "disable" (attached picture) then added the boot argument in its place and after reboot I reset nvram Was I right about the video patch? because it couldn't boot and stuck before the logo shows up. 1648318309054.jpg.zip
-
Maybe it's only my laptop's issue with this method of installation Bcuz I found some similar problems here but the solutions didn't work out for me Should I stop installing or this is solvable? Thanks for your help
-
Unluckily result is the same as it was I downloaded CpuTscSync.kext.zip from this site ,unzipped it ,and copied it into EFI/OC/Kexts/ Then tried it with the clover EFI but there was no change in the end. Any other solution? I also tried adding -igfxvesa for first time and npci=0x2000 for second time, still doesn't boot.
-
As I said I used this EFI folder in first try but unfortunately it didn't work and after the logo of apple appears suddenly there's a black screen which is stuck and I can't do anything there Would you check the attached zipped video? VID_20220324_230150.mp4.zip
-
I wanted to install MOS Monterey on my laptop by following this instruction but something seems to be corruped. My system is: Intel i7 6700hq (Skylake) 16gb ram 256gb SSD Nvidia GTX 1060 I don't have access to a mac And also I did what you said (SATA AHCI mode and tried both on/off secureboot) Using a USB2 32gb flash drive I followed the steps carefully but I can't go more than step 4 because before entering the installer apple's logo shows up and fills about 20% then a black screen with my mouse cursor stuck at the up_left corner of my screen comes. As my CPU model I downloaded Skylake notebook EFI folder and unzipped it (an EFI folder and an __macosx folder appeared, at that time I didn't know what was that __macosx folder so for first time I continued without it as the recipe said but after facing the mentioned problem, for second time I copied it too and for third time I merged EFI folder inside it with the main one but none of these worked). I also tried clover EFI folder after a raw reburn on flash drive because the opencore EFI didn't work out with reset nvram for both of them but nothing special happened. Thanks for helping.